Published on: 2026-06-15
Source: KAMAZ – An important disclaimer is at the bottom of this article.
General Director of KAMAZ Sergey Kogogin and the company’s top managers visited LLC CF KAMA, a subsidiary of PJSC KAMAZ, specializing in the production of gearboxes.
The head of KAMAZ, Sergey Kogogin, his first deputy – the executive director of the company Irek Gumerov, as well as the deputy executive director for development – the chairman of the board of the auto giant Evgeny Leonov inspected the production of LLC “CF KAMA” accompanied by General Director Yaroslav Karmanov. The inspection route included four locations. The starting point was the assembly production. The head of KAMAZ was shown a schedule of equipment utilization efficiency over five years.Recovery of the indicator to the level of 2020 has been noted, reflecting the work done by the team on deliveries and the quality of components.
Special attention was paid to the takt of the transfer box conveyor, which depends on the incoming requests. At “CF KAMA,” work is being done on a standard takt series for the assembly line to achieve smoother and more efficient adjustment of output according to consumer demand. This primarily implies the arrangement of people on the conveyor. In addition, during the visit, the Kamaz inspection team examined the section with equipment and the line where the robotic AKPP (automatic transmission) assembly is planned.
At the “CF KAMA”, standardized workplaces were shown. Such workplaces exist both at the shaft manufacturing section and in the gear production. The setup operator, moving to another line, will not waste time searching for cutting or measuring tools, as they know exactly in which drawer these are placed.
The setup table for manufacturing parts is yet another improvement demonstrated to Sergey Kogogin. This element helps save time for the equipment adjuster, who now does not need to go to the tool section where all the tooling was previously stored. It is now under his hand on the table in production.
The executives also visited the production measurement laboratory for parts, where they were told about the Andon system.“It allows transmitting information about the quality of the part directly to the line. Special equipment — a traffic light installed on the line — shows the measurement status of the part — whether it is acceptable or requires adjustment. Now the operator does not need to spend time moving to the measuring lab and finding out the part status., – explainedProduction Director of “CF KAMA” Dmitry Khvoshnyansky. –At the same time, with the help of this system, we can monitor the measurement time, understanding how long the measurement itself takes, and how much is spent on equipment adjustment.
“CF KAMA” is one of the best enterprises in terms of technology and production culture compliance. Here is a united team that values its workplaces and preserves these production traditions laid down in the CF KAMA project. This is a great merit of the team. And if we set some new tasks before it, it will surely accomplish them., – summarized after the discussionSergey Kogogin. –It was pleasing that every speaker understands what they are talking about and notes which aspects can be improved.
Please note; This information is unprocessed content, obtained directly from the information source. It represents an accurate report of what the source claims and does not necessarily reflect the position of MIL-OSI or its clients.